it says in neutral wire current flows under normal condition,
but when we put tester it wont glow, why?
- 7 Answers
- 7749 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / sudha
Thank you Liaqat Ali Khan. but in many sites it has given under normal condition current flows in neutral.
For Ex refer
http://uk.answers.yahoo.com/question/index?qid=20070808043421AAk35Fc
http://wiki.answers.com/Q/What_is_the_difference_between_a_neutral_wire_and_a_ground_wire
http://en.wikipedia.org/wiki/Ground_and_neutral
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how to test YNyn0 vector group in transformer?
what is difference between speed mode and torque mode in motor?? explain in simple words please.
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
explain safety measures in alternator?
Why reactors use before incoming of ac vvfd drive?
what is interpose? where it is used and why it is used?
what happens when series resonance occurs?
What will happen if the voltage in my house drops from 220V to any lower voltage?
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
what is saturation kit?which use above 15 kw motors panel side.
Give some example of fault limiting devices?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
State thevenin’s theorem?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
