Interested to Buy Any Domain ? << Click Here >> for more details...
A 60w bulb & a room heater are connected in series.if 60 w
bulb is replaced by 100w then what will be the effect on
heater out & why?
- 6 Answers
- 16570 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishak
Required heat will not get because the in the area of 60kw
we are placing 100kw at that time amount of current utilized
is increased .As the current drawn is increased then the
voltage will get drop . this will affect the heater
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
what is booster? and how it is connected in a circuit?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
Brief me about maintenance planning & sheduling of machine tool.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
what is cascade speed control device?and how this device control the speed of motors?
Define stepper motor. What is the use of stepper motor?
what are the assumptions made in swineburne's test?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
How to select a cable size for particular load?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
can anyone give an idea about dia calculation in cold rolling mill
How to calculate the sag of OPGW during stringing???
wat is the first thing dat is needed, 2 lay a cable in some area??
