Interested to Buy Any Domain ? << Click Here >> for more details...
Why the Proximitor supply should be Negative voltage? Why
should not we give Positive voltage to the Transducer?
- 6 Answers
- 16408 Views
- Moser Baer, I also Faced
- E-Mail Answers
Answer Posted / rajesh
because wrt positive supply other running cables negative
voltages will interfere to the proximitor supply voltage.
to avoid unwanted signal interferance we are using negative
supply.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
why fuse block is not used for AI signal?
Explain types of valves?
Whatis the reset ofset and control system in instrumentation
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
What is the meaning of wet leg
how to calculate control valve bonnet size?? or how to select its material?
How to calibrate smoke Dectector
Can I calibrate the Electromagnetic Flow Meter on line and How.
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
what is the protection system in solar turbine compressor
why we are using digital signals for I/O & how to measure this signals is getting or not ?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What are different types of orifice plates?
