Interested to Buy Any Domain ? << Click Here >> for more details...
What is phase angle? and what is importance to measure it?
- 2 Answers
- 5134 Views
- I also Faced
- E-Mail Answers
Answer Posted / @vi
Phase angle is the phasor angle between the voltage and
current. It is very important which determines the real
power delivered to the load..
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
In motors how many types of cooling systems were used?
plz tell me,ht and lt panel terminals in substations explain beiefly
how mass curve differs from hydrograph.
Why in ESP Positive earthed
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
why the carbon brushes are broken in srim while the motor runningtime
Why CBCT rating is 50/1A
How to calculate per unit impedance of transformer?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
State any two nuclear power stations in India, with their generating capacity.
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
Draw a block diagramof Three UPS systems connected in Parallel mode?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
