i/p converter always for supply pessure from 3~15 psi
only !! And from where this converter bleed the air.
- 2 Answers
- 4432 Views
- I also Faced
- E-Mail Answers
Answer Posted / sushil d. jambhulkar
IN I/P THERE IS A FLAPPER & NOZZLE SYSTEM,CONVERTER BLEED
THE AIR FROM NOZZLE.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Explain the combusion chamber
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
what is stroke check for field instument transmetter's & AOV's
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
what is the difference between attemperator and desuperheater ?
Can anyone send most commonly asked interview question in Oil & Gas industry
Draw a great bridge circuit.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
