Interested to Buy Any Domain ? << Click Here >> for more details...
what is subtransient , transient and study state ac components
- 2 Answers
- 10170 Views
- I also Faced
- E-Mail Answers
Answer Posted / chunkey pandey
These terms appear in the calculation of fault currents.
Common sources of fault currents are rotating machines,
i.e., motors and generators. An important factor in
detrmining the magnitude of a fault current is a variable
reactance that changes rapidly after the initiation of the
fault until it reaches a steady state.
Subtransient Reactance:-usually denoted as X''d (X double
prime sub d), is the reactance used to determine the
current during the first cycle after the occurance of the
fault.
Transient Reactance:-In about 0.1 second this
reactance increases to the
level known as Transient Reactance usually denoted as X'd,
and after 0.5 to 2 seconds it increases to the leven known
as Synchronous Reactance and denoted as Xd, and this
determines the fault current after a steady condition is
reached.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
In Plumbing services What are accessories we consider for a bathroom?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
what is the difference between RMS & TRUE RMS VOLTAGE
please give me solution to rectify the emi(electromagnetic interference)
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
what is control supply rating of a machine
what do you mean by class PS CT and what are technical details needed for calculating it?
what is distribution board?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
What will be the effect if I use inverter as UPS mood?
