Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sushil jambhulkar
PLC USE TO CONTROL ANY PROCESS BUT DCS USE TO CONTROL WHOLE
PLANT PROCESS.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Explain bernoulli’s theorem.
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Programmable Logic control.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what are the selections available in configuring a burnout protection of a controller? thanks
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
Tr. Wiring for calibration.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
Explain the key components of control loop?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Can anyone send most commonly asked interview question in Oil & Gas industry
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
