Answer Posted / satish
14.50
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
What is the difference between isotropic material and homogeneous material ?
draw IRON-CARBON diagram.
Define the term latent heat.
Is your basic salary of $...... , good for you if employed?In case of any eventuailt,who is your next of kin?
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
a rollin mill is spacified by
explain the omportance of "squish" and "swirl" in ci engine
Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?
What is the detailed meaning of automotive clutch endurance test and inertia test?
Effect of surface finsh & surface roughness on coefficent of friction in form press tools.
what is the techanical difference between german standard & japanese standard.
where we can get the surfacing modelling project of example to practice in catia.
What are the causes of damage to propellers?
What was the hardest part of obtaining your engineering degree?