Interested to Buy Any Domain ? << Click Here >> for more details...
CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE IT
AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND
TAKING OUTPUT FROM PRIMARY?
- 3 Answers
- 5479 Views
- I also Faced
- E-Mail Answers
Answer Posted / mamchand saini
yes we can but for this we have to know primary current of the t/f and secondary current of the t.f and take this according same ratio.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to measure earth resistance of a substation
why only exciting current is shown not primary current in transformer???
What is George phenomena to start the synchronus machine?
how current is reverse from its normal direction during the fault?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
in dc shunt motor if field winding is shorted then
How grounding is different than earthings?
What happens if i apply 500V to 440V rotary Switch ?
Which level of the Transformer oil got dielectric strengh? And why?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
some basic standard questions on transformer.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
What is the general system requirement of alternator?
what is the control circuit for operating the clean room air shower
