During Load testing of battery charger with temporary AC Generator .When reach 70% load Generator immediately shutdown .we could not able to Recognize ,what is exactly problem .Please kindly clarify us
Answer Posted / binod
AS WE HAVE TWO PART OF THE PROBLEM.
1ST PART IS GENERATOR &2ND PART IS LOAD TESTING OF ABATTERY
CHARGER.
1ST-1) THE GENRATOR IS DTIVEN BY THE ENGINE.
CAPCITY OF ENGINE TO RUN THE GENARATOR FOR DELIVERING ITS
FULL LOAD TO BE CHECKED BY ANY OTHER MEANS. INTERLOCKS OF
TEMPRATURE VARRIATION OF GENERATOR TO ENGINE BE CHECKED.
2ND- CONNECTIONS TO BE VARRIFIED,BATTERY CHARGER
SEMICONDUCTOR ELEMENTS RATING HEALTHYNESS &CAPACITY TO BE
CHECKED.THE LOAD WHICH IS GIVEN TO TEST IS CHECKED IN
INCREASED TEMPRATURE.THE LOAD MAY BE SHORT CIRCUITED AT 70%
CAPACITY WITH INCREASED TEMPRATURE.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
What is meant by Low Resistance Cable and High Resistance Cable.
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
Why can't we parallel the secondary circuits of two voltage transformers?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
why we not used 11kva as a direct our electrnics component.
what is the practical application of full adder circuit?
2. What are the parameters of EHT sub-station?
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
Define maximum demand?
What is meant by vector group
Explain using drawings what is reverse PID action w.r.t PID controllers.