Interested to Buy Any Domain ? << Click Here >> for more details...
how can calculate static 3phase 4wire CT & PT operated
energy meter constant when calibrating using refference
meter suppose we have 11kv/110v PT and 30/5A CT, the meter
constant is 160imp/kwh, where meter is showing MW energy?
give me solution which constant i feed in my refference
meter for calibration of energy meter?
- 3 Answers
- 21795 Views
- I also Faced
- E-Mail Answers
Answer Posted / shah
This question set is prepared based on India's requirement.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
STATE WORKING OF VACCUM CIRCUIT BRAKER?
What is the difference between resistance grounding system and resistance earthing system?
Classify drilling machines.
What is Negative Potential Bias
IN dc capacitive reactance is??
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
I need HT sphere gap calibration table. Can any body help me.
Brief working principle of stabilizer,application & safety precautions
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
What is Control & Relay Panel? And Remote Control Center?
explain safety measures in alternator?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
can i connect wavetrap in 2 different phase in EHV line?
