Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / reza r
Setup time is the time before the edge of the clock (In a
flip-flop) that the data must be held steady to be sampled
correctly.
Hold time is the time after the edge of clock that the data
must be held steady to be fully applied to the FF.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
....................... regulator operates the power transistors as high frequency on/off switch. A Series B Short C Switching D None of these
Can you help me correct FM transmitter circuit?
what Rx and TX power good RF conditions.
write a c programme for add of two numbers with out use of arthematic operators
can anybody mail the exact sylabuss for ECIL
what is difference between xdm-50/100/300/500/1000/2000 & all bg-20/40/30 in eci mux.
What are the characteristics of ideal opamp?
i am preparing for AAI JR EXECUTIVE exams so plz suggest the objective materail for preparation
What is the approximate cost of the monitoring cables time domain reflectometry?
What are the losses that occur in a thyristor during working conditions?
Define what is tunnel diode?
Explain in wave guides tem wave propagation is not exit, give the physical interpretation?
What are digital electronic flip flops, state the different types of flip flop and their uses?
Explain what is a truth table?
How is the keycode calculated while interfacing a keyboard with a microprocessor?
