Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nikhil s shah
Carbon brushes are used to connect external circuits in a
motor or any other machine to the rotor (moving part of the
machine) through the commutator. You can also say that
these brushes transfer electric current to moving part of
the motor or machine.....
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is the advantages og idmt relay over magnetic relay??
What is the difference between isolators and electrical circuit breakers?
why does make gain margin and phase margin on same plot.?
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Can you explain about pole discrepancy scheme
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What is servo lock in CNC how they work and if any parameter for them in CNC machine
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
What happen Grid EARTH plat got cut.
