What should be percentage of silt content in sand?
- 11 Answers
- 21419 Views
- TCIL, I also Faced
- E-Mail Answers
Answer Posted / qc
Material finer than 75 micro meter (No200) sieve:
Concrete subject to abrasion is 3 average
and All other concrete is 5 Average(mass percent of Total
Sample,) max
Ref:ASTM C33-02a Table-1
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Describe the various methods of concrete curing?
where can i get the previous question papers for rrb section enginerr (civil)
What is eccentricity in laymans term Can't understand bookish language .please explain in easy way.
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.
what is the formula to find the sttel (bar)length in beam having bent up at l/4 t 45 degree & 60 degree.
what is meaning of inverted beam.is it way to provide double mat in slab one at bottom and another at topif we go for provision of inverted beam. shall we construct structure with out plinth beam for us we have to construct small bus shelter
What will you do if a portion of load bearing wall collapses under your supervision?
How do you prepare Material Recovery Statement for deduction from contractors bills?
How will drive weight formula for circular cylinder steel bar in kg/ m please step by step drive?
Iwant to calculate the production of 1 labour for concrete casting which includes shuttering,scaffolding,steel fixing,concreting, deshuttering and curing in 8hours.But i am not able to determine it approximately would you pls.??
if size is 235cmsx15cmx100cms so how many cement bags and how many sand bags are used for concrete mix
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
how many type of admixtures for water stored structure?
Did any of the egyptian pyramids ever fall down?
