Answer Posted / bhabanipattanayak
Starter is mainly used for
limiting the high starting
current to a safe value. It is
also provide with different
equipment to protect the
motor from overload & low
voltage.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Name the test signals used in control system
What is dc current source? Differentiate between ideal and non ideal current sources?
What is the approximate value of stacking factor?
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
How wire size can define in electrical wiring? What is the ratio?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
what is die electric strnth of transformer ?
how to calculate the fault in substation
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
Earth leakage relay basic knowledge principle
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
