ALONG WITH
MEGGER TEST FOR
CHECKING OF
MOTOR ,WHY WE
MEASURE FOR
RESISTANCE AND
INDUCTANCE?
- 4 Answers
- 8279 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / erharisheee51
i Guess Megger test means Insulation Resistance test ..using
Megger test itself we can able to find the insulation
strength interms of resistance only ..
so what is that question ? please be clear that resistance
and megger test are similar ..
and remaining inductance test i don't know that ..
is it correct , Please clarify
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
How to determine alternating current frequency?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
What is transformation ratio what it describes?
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What is mean by STUB protection?
What it the purpose of parallel phasing transfomers??
what is positive , negative & zero equivalent system resistance
What is the capacity of the Fastners 12mm?
what is the function of Moulded case circuit breaker, why it is called Moulded?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How you calculate the repturing capacity of a HRC fuse
Differentiate between induced emf and self inductance?
