Why high voltage lines (overhead ) are called high tension
lines?
- 8 Answers
- 31604 Views
- I also Faced
- E-Mail Answers
Answer Posted / changiz
I agree with No 5 and 6
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
what is accuracy ? in any meters , coils accuracy . how can u defined that ?
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
I completed iti in2004 I was worked in A grade contractor can I get c licence
Why is the starting current high in dc motor?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What are the specifications for conducting earth leakage test as per IEC standard?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
What are the necessary components of the feedback control system?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
How would your past experience translate into success in this job?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
pre arcing time of ehv breaker
