What is A check, B check, C Check & D check for a diesel
Generator? Please guide me as this question was asked many
times and till now i haven't get right answer.If you can mail
me then please mail me the answer @ yogiagarwal@gmail.com.
Answer Posted / bhogesh biradar
DG A Check
this check is preventive maintainance of DG sets(1000-1500KVA).
1) A-check is done on daily basis here we check:
a) oil level
b) coolant level
c) gauge valve level
d) check for any leakage.
e) cleanliness of DG set.
2) B-check(done after 300hrs of cycle or 6 months whichever is earlier. )
a) check lube oil filter
b) fuel filter
c) air filter
d) bypass filter
3) C-check(done after 1500hrs of cycle or 3 yrs whichever is earlier.)
a) all steps of b-check.
b) check/change of air filter (if needed).
c) check/change of other filters mentioned in b-check.
d) change of gasket of chambers.
4) D-check
a) done in 6000 hrs of cycle.
| Is This Answer Correct ? | 101 Yes | 22 No |
Post New Answer View All Answers
How do I calculate 2% Butane in 29.66 CFM?
where is the steam trap connected in boiler distribution?
DRDO entrace exam questions for ceptam please forward for this mail.pls immediately
Under what circumstances would there be an increase in pressure in a diver¬gent nozzle ?
What are reasons for poor machinability for IS 2062 steel
What are the causes of failure of superheater tubes ?
At 50 Centigrade (Fuel oil) what is its cast?
What are the properties of fuel oil?
How much is the work done in isochoric process ?
What do you measure in the banana and mountain diagram?
What is meant by parallel flow heat exchanger?
sir,iam applied rrb chennai for the post of junier engineer,i need objective type question book,please refer the suitable book,author and publication.
Explain how do motion detectors work?
what is the technology used in sap?
What will happen if boiler backfires?