Interested to Buy Any Domain ? << Click Here >> for more details...
What is two wire system and how it work
- 2 Answers
- 7334 Views
- Bhel, IFFCO, I also Faced
- E-Mail Answers
Answer Posted / amit
two wire system means power supply of instrument and signal
output both communication coming through 2 wire only.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Explain how thw analog to digital converter works with the circuit diagram
How process line mpm calculation is done?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
what are the selections available in configuring a burnout protection of a controller? thanks
What is three element drum level control system why its better than single element?
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
How u measure the massflow in orifice flow measurement techniques
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
How d.p. Transmitter can be applied to open tank?
send me HPCL paper
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the difference between ff transmitter and non ff transmitter
what is interface level and how it is calibrate?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
