Interested to Buy Any Domain ? << Click Here >> for more details...
how many bricks are consumed for 01 Cum of brick work
- 10 Answers
- 15110 Views
- Fusion, IVRCL, I also Faced
- E-Mail Answers
Answer Posted / kaushik shah
if the brick size are 0.19 X 0.9 X 0.9 i.e standard size
then 550 nos bricks are required (including wastage) in 1 m3
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
what is BPM in concrete demolition hammers. what is better a higher value or lower
Difference between pre-tensioning and post-tensioning.
it is a corrected question." make a list of engineering property(properties) of soil.
crank types
foundation details for 25 ton weight Furnace on 2 supports and 2 tilters
How to do base isolation for RC framed structure using ETABS software?
Howmuch bend to be provide for 200/600 BEEM
how to calculate the strength of rebound hammer test reading in building construction ?
How many hours should traffic be not allowed after completing wbm road or bst.and min how many hours should road rollers be used.
Civil engineering material testing Standard results
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Please tell me Detail cost of providing& laying nominal mix design 1:2.5:5,40mm nominal size.curing complete e/c cost of form work in foundation and plinth i/c carriage.
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
In cement concrete how to check a quality of material also proportion of material at site ?
how to preaper for interview wat they asked in interview give me idea
