What are the various types of LT panels? Name them.
- 3 Answers
- 13454 Views
- Tyco, I also Faced
- E-Mail Answers
Answer Posted / raghavendra.
Only Two types of LT Panel,
1.Outdoor LT Panel.
2.Indoor LT Panel.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
what is meant by 3rd hormonics ?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
is there any current and voltage drop on liquid resistance starter water/soda tank ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
What are the different types of LT Cables?
What is dc current source? Differentiate between ideal and non ideal current sources?
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
