Answer Posted / raj

Potential transformers are instrument transformers. They
have a large number of primary turns and a few number of
secondary turns. It is used to control the large value of
voltage.


WORKING:
The potential transformer works along the same principle of
other transformers. It converts voltages from high to low.
It will take the thousands of volts behind power
transmission systems and step the voltage down to something
that meters can handle. These transformers work for single
and three phase systems, and are attached at a point where
it is convenient to measure the
voltage.e.g:11Kv/root3/110v/root3 for delta connection.

In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?

2064

---

how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?

2685

---

How 3 phase invertor works?

2123

---

TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.

2632

---

how to calculate voltage drop and followed by cable calculation?is there avail in formula?

2115

---

what is the difference between earth leakage and earth fault?

2386

---

Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??

1751

---

how can we change the phase angle b/w two phase?

5259

---

Why hydropower stations are preferred solution for meeting peak loads in grids?

1054

---

Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?

2084

---

what is rocking arrangement in arc heating

2181

---

I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting

1512

---

EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)

8350

---

What are the advantages and disadvantages of the ac motors?

1194

---

how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .

2322

---