Interested to Buy Any Domain ? << Click Here >> for more details...
what is the formula and technique for duct designing?
- 1 Answers
- 3538 Views
- I also Faced
- E-Mail Answers
Answer Posted / md zahooruddin
duct designing manaully
Q = AV
Q = cfm
a = ?
v = velocity
then
A = w*h
h = height according to site
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is meant by indirect contact heat exchanger?
hi sir would u plz kindly send me d previous years IOCL test papers......plz send it to this email id...jomygeorge787@hotmail.com
hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.
what is the techanical difference between german standard & japanese standard.
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
What are the different types of brakes and explain them?
wt is MAG weld? wr it is specifically used and reason for it .
Hi where can i get catia v5 r16 help files
respected sir, i had applied for the post of GET for JSPL so kindly send me the syllabus and exam pattern for the concerned examination. my mail id: starsunny49@gmail.com thanking you sir
What does a rolling offset look like?
Under what condition a convergent divergent nozzle required ?
What are the causes of dirty lubricating oil?
Why are not use ball bearing insted of roller bearing?
What is the difference between scavenging and supercharging ?
What happened if the exhaust valve is leaking?
