what is the function of breather in a transformer
Answer Posted / vishal kumar sharma.
As the transformer oil (used in transformer for cooling in
oil tank) is a very costely & important for transformer.
Its provide cooling to windings as well as inolation.
If the moisture mix in this oil, its electric resistavity
is decrease which is harmfull for the windings and the oil
life is also decrease. As we use a silicon breather in the
input way of air, which comes when temperature of oil &
windings decrease.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
Can a generator runs after getting 1st stator earth fault.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
how to check avr of dg set of 125kva
what happen if drive input fail momentry at 48.5 HZ frequency?
what is the advantage of connecting capacitors in delta than in star?
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
Which cable is use for rtcc control panel
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
Please explain me about Relay curves and their sources to read ?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.