Which command line statement determines the number of seconds a
dialup connection can wait without any traffic before the
router hangs up?
A.) dialler max-time
B.) dialler timeout
C.) dialer idle-timeout
D.) dialer hang-up
E.) disconnect-timer
- 2 Answers
- 4677 Views
- I also Faced
- E-Mail Answers
Answer Posted / hari prasad
B.) dailer idle-timeout
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What are the different types of the password used in securing a cisco router?
What is the multicast routing?
Why is vlan used?
Which way of communication bus topology use?
What is the virtual path?
How is private ip different from public ip?
Explain how many types of ips?
Explain how many maximum paths you can give on latest ios in rip?
Why mac address called physical address?
What is formula of hold down time of eigrp protocol?
Name the protocol which can do load balancing on unequal cost also?
Explain why ip address called logical address?
What is BootP?
Which type of transmission bus topology support?
Which protocol comes under hybrid dynamic type?
