Answer Posted / op singj
S=120f/p so speed prapotional to frequency.when motor running is rated speed then takes rated current.if we have requirement low speed of motor than we can reduce frequency according rwequirement load or speed.VFD works on frequency according load we can speed increase or decrease by frequency increase or decrease.Thanks.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
What is the practical way to calculate the cable size for known ampere load?
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
what type questions asked in hp cl
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What is the actual meaning of thermal power efficiency ?
What is the source of dependent source ?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
What is an ideal transformer?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what transformer we used normally and upto which kva?
define hysteresis loss, eddy current loss and windage loss
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
low frequency protection why recomend?
