Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between voltage and current?
- 11 Answers
- 15936 Views
- I also Faced
- E-Mail Answers
Answer Posted / samlesh singh
Flow of electron in conductors is called
current and potential difference
between tow end of conductor is called
voltage
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the raitings of Mcb,mccb and Acb in detail ??
how to size H.T & L.T Panel ?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
What is the real function of reverse power relay in generator panel while syncronising?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
What current flows in the transformer primary when its secondary is open?
What happen Grid EARTH plat got cut.
What is the most important precaution in any experiment with d.c. Shunt motor?
why and how current drawn by battery charger depends upon the altitude where it is located?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
