Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bunny
Valve positioner is an instrument used with automatic
control valves,not with a manual valve.An automatic control
valve open/close basicaly according to the control signal
from a controler(e.g a PLC),say,4-20MA.For every control
signal comming from the controler,there would be a
corrsponding position for the valve plug,which determines
the flow rate.But in practical applications,the valve
position might not get maintained by the controller action
alone.So if there is any deviation in that position,we need
to rectify that and for that we are using a valve
positioner.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
How to change dcs card in online. (Dsc is maxdna)
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
draw the block diagram of a level transmitter ?
which type inter lock use in petrochemical refinery,and oil & gas?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
What is modbus?
How is work 5/2 sov?
List three types Level Switches with their working principles
what is span value and zero ? and how set ?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
What is frequency factor in massflow meter? When using frequency output?
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
