Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bunny
HVAC stands for Heating,Ventillation and Air
Conditioning.HVAC system includes Chillers,Air Handling
Units(AHU),Fresh Air Handling Units(FAHU),Fan Coil Units
(FCU),Boilers,Variable Air Volume Units(VAV),Constant Air
Volume Units(CAV) etc and all these equipments work
together to maintain the temperature(hotness and coldness)
of a building.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
Why not come out analog output in ABB EL3020 when display show correct value
principle of dead weight tester ?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What is first echo & echo window in radar type level transmitter?
How to decrease opening & closing time of on/off valve?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
for oil & gas industries which zone is normally preferred? why? give its example?
Isometric drawings are generated during _________________ phase of a project
What are the types of control valves available
