Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / agathiyan r
thermocouple:
thermo means related to temperature and couple means joint of two;here 2 dissimilar metal are coupled together to measure temperature for higher degree;
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In apron feeder how TPH is calculated?
Why humidity limit is 30 to 55 % for raw material storage?
how to relay switch sense the fault?
what is easiest way to read STL language in PLC?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
Which products are available in the Mass Systemswitch and System Manager AC range?
With N nodes and B branches what will have a network ???
How to calibrate Toxic gas detector?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what are the diff. in servo and regulatory control?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
What is the use of control cable?
components of control circuit belongs to control valve
Gas equation
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
