Interested to Buy Any Domain ? << Click Here >> for more details...
Why DC current is not used in transformer?
- 20 Answers
- 43076 Views
- JK Paper, TCS, I also Faced
- E-Mail Answers
Answer Posted / arun
dc only produce the steady flux
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
What are gain margin and phase margin?
what is meant by re-rolling motor? how it differs from standard motor?
What test must you do before powering up a circuit that you have been working on?
How can ou verify the size of conductor 50Sq.mm ACSR
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
I want single line diagram for AMF & DG syncronizing panel
What is the source of dependent source ?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
Iin ESP why positive is grounded ? why not negative ?
What was your role in the silicon evaluation/product ramp? What tools did you use?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
