what is the difference between star and delta connection?
Answer Posted / kavitha
star connection used for 3-wire& 4-wire system but delta
connection used for only 3-wire system.In star phase&line
currents are same ,voltages are different .In delta phase
&line currents are different ,voltages are same.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Define sensitivity?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
what is integrated ac contact circuit
How to connect the chemical earthing and complete process tell me plz
Which device is used for the source of emission of electrons in a crt?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
What are the components of feedback control system?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
What is Instantaneous Earth fault relay,how will work