What is Star Delta Connection, where it is applied & what
for it is used
Answer Posted / shashank
it is to reduse high starting current. it applied to high
cap motor like Above 10 hp. it means motor should run star
connection to reduse the starting current after she running
in delta in half of normal currunt.
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
how to calculate short circuit current for the busbar
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
what is RNG in the DG synchronizing by PLC?
Define step response?
Define branch?
Details about Flux Compensated magnetic Amplifer starter for motors
how braking & making capacity of circuit breaker are calculated?
In vapour absorption refrigeration machine fluids used are
how do you test tachos and servos
how much allowable resistance that can be difference in motor all coils?
how can we design robots
how to modify DOL control panel into Delta Y connection?
What is the numerical quantity of sqcm?