Interested to Buy Any Domain ? << Click Here >> for more details...
difference between sub cooling super heating
- 7 Answers
- 14453 Views
- Hyundai, I also Faced
- E-Mail Answers
Answer Posted / al domingo
Subcooling - in the system condenser,conversion of vapor to
liquid involves removing heat from the refrigerant at its
saturation condensing temperature...any additional
temprature decrease is called
subcooling.
superheat - in the system evaporator,conversion of liquid
to vapor involves adding heat to the liquid at is boiling
temperature,commonly to as saturation temperature..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
What is "H7014C/HQ1P4 BEARING" means ???
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
What causes hardness in steel ? How heat treatment alters properties of steel ?
Classification of bunkers?
What is gtsc technology?
What will you check if one cylinder of your engine is not like the others?
I've been running into situations where a relief valve is being used to protect a regulator. Is this common? And, is this a proper use of a relief valve?
Why is thick steel wire stronger than thin steel wire?
please send jindal steel and power model question papers
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
What are the typical indicator diagrams?
What is the device that converts sound energy into mechanical energy?
I have a 2000 Chevy Blazer and when turning on the A/C the accuator opens and closes the panel doors on its own without me touching any controls..i bought a new climate control (350 dollars) and that didnt fix it..can anyone help??
What type of cross-section is usually of a chisel?
