Interested to Buy Any Domain ? << Click Here >> for more details...
how to convert 1 phase power to 3phase power by using
induction motor. . . .
- 1 Answers
- 3855 Views
- BK Anand, I also Faced
- E-Mail Answers
Answer Posted / pckundapur@gmail.com
Couple motor with a 3 phase gen
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
can u please mail me the syllabus for GET exam for damodar valley corporation?
How we can defined theecopper cable size if we know the aluminium cable size?
Why the arms of delta in a delta-wye power transmission system are kept constant??
what will happen if there is a voltage leakage or current leakage in an electrical train
Why derivative controller is not used in control systems?
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
what is the difference between capacitive and resistive voltage divider?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
