Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manoj s patil
Let us take an example,
if you say 1kW,the device consumes energy of 1kJ of energy at 1sec. this tells you the power consumption.
if you say 1kWh, this means, the energy consumption is 1*3600=3600kJ of energy. this only tells the total amount of energy consumed.
if your house electric bill says 100kWh/month, then it means to say that you have consumed 360000kJ of energy.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is the permissable nutral current of three phase system as per IS standards?
What are the Full Forms of TVM, MTL, CVT ?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
What is the function of the circuit breaker failure relay?
What are the advantages of nichols chart?
what is meant by neutral compensation factor and where it is used
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
what happen when power factor of 2 parallely operated transformer become equle?
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
Why neutral point is consider as zero potential?
What is the actual calculation for transformer short circuit test?.
While testing a ZCT what parameters have to check or measure?
