Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / saad
NGR Neutral ground resister
NGR connected between earth and star point of generator
during normal condition only limited current or zero
current flow in the ground side but during fault there r
too much current that limit the NGR with the help of
resister and relay setting according to that minimize
current that tripped the breaker of generator
Have a good day man
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
What does the term power factor shows?
direction of tarbine& genrator
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
Explain Even and Odd signals?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
How to address the servo drive for motor
List out the different frequency domain specifications?
How to discuss the phase shift of transformer considering open delta?
Igfet is a
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
