Interested to Buy Any Domain ? << Click Here >> for more details...
Why selected cable colour red yellow and blue in 3 phase
Electrical system?
- 9 Answers
- 24575 Views
- Crompton Greaves, Essar, Gridco, I also Faced
- E-Mail Answers
Answer Posted / suhail
Those are standard colours
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
what is meant by impedance & transient protection?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What happens if the series current double?
What is meant by a stray loss of a induction motor??? What is the equation to find it
What is bode plot?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
what are the ''pitting rings''and how cn they be controlled in a series generator
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
What mean by MLTP
explain the types of drives
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What test must you do before powering up a circuit that you have been working on?
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
