Interested to Buy Any Domain ? << Click Here >> for more details...
How can we save electrical cost i.e switchgear, wiring,
conduiting etc in a room?
- 1 Answers
- 3751 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
Can we Co-ordinate relay in Load Break switch?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
Differentiate between ideal and non ideal current sources?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
what is meant by moulded case circuit breaker ?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
surge tank, hrc fuse, earthing transformer, firm power objective type
Starting Time of LT & HT Motor
oil cooled transformer
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
HOW TO CALCULATE THE VT SIZING?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
