Interested to Buy Any Domain ? << Click Here >> for more details...
What is the range of the stator resistance of 3 phase
induction motor?
- 1 Answers
- 5766 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
In case of squirrel cage it is almost zero and in rotor
wound, it depends on HP.It decreases with HP.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
What is the formula to calculate a three phase alternator
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
what is the meaning of 0.5ohm Resistance
how pt is using
At full load wat is the motor p.f And at no load will is the motor p.f?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
What is transmittance?
what is the terminal voltage of dc series generator running at rated speed at no load?
What are the factors influence the choice of an electrc drive?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
