Interested to Buy Any Domain ? << Click Here >> for more details...
What is the standard height of installation of Socket &
switch from Finish Floor Level as per the IEC/IS Rules?
- 1 Answers
- 4124 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradyumna171
Socket & Switch board should be 1300mm-1500mm from F.F Level as per IEC/ISE Rule .
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
Fantio of tranformer
how much leakage current is allowed in MC61A L&T make relay?
EXPLAIN THE ESSENTIAL FACTORS WHICH INFLUENCES THE CHOICE OF SITE FOR A HYDRO ELECTRIC POWER PLANT
i have a 1500kVA transformer what is the kWH meter i need to use?
mccb service sittings be done?
What is the exact minimum vale of voltage between an earth and netural which can damage or can do malfunction of the electronic equipments ? If this is mentioned in any book, pl.give reference.
Did RMU have ct and pt ?
What is the working principle of servo motor? And explain it.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is the meaning of 5% droop or 7% droop in AVR?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
What are safety device in vcb and acb?
DG SET BLOCK DIGRAM
What are dependent sources?
