Answer Posted / jsrana
TS 456
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
How much cement and sand are required for 1 square feet of plaster at a thickness of 15 mm at a ratio of 1:4?
For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?
how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress
How to calculate the area of a irregular sized land in square feet?and what will be the total area of this land South-51.1ft , North-47.7ft , East-53.3ft , West-54ft ?please explain me how to calculate?
what is anchorage length,lap length and (dont remember the last one)
What is oneside mat. And explain
in the construction of residential building what type of tank are used?where?why & what is its purpose?
how much repeitation for conventional and maivan formwork?
Explain what is the difference between built area and super built up area?
What is the strength of 1:6:12 mix?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
What do you understand by “preset” during the installation process of bridge bearings?
What is passive earth pressure ?