Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / g.arjun
PLC is programmable logic control which is used for the automation of Electro Mechanical Process.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
how to measure draft pressure in transmitter pl. give its single line digram
Pl send the model question paper of mahagenco account officer post
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
what is effect of specific gravity in differential level transmitter , explain formula related with this .
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
how can use ram
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
why Fahrenheit unit of moistur analyzer transmitter
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
What is difference between radial vibration and axial vibration explain in detail .
