Interested to Buy Any Domain ? << Click Here >> for more details...
WILL THE PERCENTAGE IMPEDENCE FOR A ONAN TRANSFORMEER BE
THE SAME COMPARED TO ONAF TRANSFORMER OF SAME RATING???
- 5 Answers
- 12721 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya dev
Imopedence is depending upon the core winding and rating
capacity, it is not depending upon the cooling system.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
What is meant by system?
What is the name of the winding from which the supply is taken for load connections?
Where can i get practical knowledge of solar system?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
How can a equal potential zone be carried out in conductors?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
why we have and use 3 phase not 2 or 4 or other in power system?
How to test Alternator stability test for REF relay
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
