Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abhishek kesarwani
Because the power factor depends on the load associated with it.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the selection process of breakers. Can any one please give a formulation on same?
what is the solution for meger test failed the MV cable?
which book to refer in electrical engineering for iocl exam & which book for general english.
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
Where is servomechanism used?
can u please mail me the syllabus for GET exam for damodar valley corporation?
what is settable hystersis protection? If any body knows plz kindly post the answer..
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
what is the id1 & id2 setting in differential protection relay of CSPC?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
Details about Flux Compensated magnetic Amplifer starter for motors
how to calculate current and voltage in a same circuit?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
