Interested to Buy Any Domain ? << Click Here >> for more details...
What is the stander resistance value between the neutral and
earth?
- 10 Answers
- 23485 Views
- Crossdomain, Sepco, I also Faced
- E-Mail Answers
Answer Posted / abhishek goswami
the stander resistance between the neutral & earth is less
than 1 ohms
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
Single phase and threephase power calculation
how to commissioning the genset with amf panel?
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
What is difference between YNyn0 and YNyn ??
Starting current of a 10 HP induction Motor is ______ time’s full load current.
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What are dependent sources?
i want to know about torque of slip ring induction motor
what is p.s impedance measurement test in earthing transformer?
how to calculate magnetic force genrated by a coil ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
How many devices can be connected in one zone of FACP
