Answer Posted / sasi

4 M

In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?

1965

---

what is working process of star delta controlling circuit ?

1872

---

how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.

2196

---

diff.between servo motor and ac motor

2046

---

H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....

1879

---

why co incidence factor considered in transformer sizing?

1852

---

What is meaning of out of phase (making & breaking) capacity And how to calculate

2226

---

How to calculate energy stored in a capacitance

1164

---

Control wiring of a dol starter for forward and backward

1576

---

How to know th details about an electrical Drawing ? Please mention the easy method.

2441

---

What is the end effect of linear induction motor ??

2018

---

if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side

1854

---

What is DC series motor?

1263

---

What are the various types of BUSBAR Schemes? explain each

5304

---

What are the special cables required for explosion proof wiring?

16685

---