Answer Posted / raseelrasheed
example,if water is flowing from bottom(bottom) to tank
(top) with help of pumpset,we know that water cannt flow to
top without help of ext. power.here the functions are
comparison
WATER-workdone--electrone
PUMP -force--battery(voltage source)
TANK -load---bulb
so the functions of voltage is supply power for dead
electrone to climb valance region and to blow the bulb
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
What is Harmonics how it is produced and what is the method to control the same
Where can I get Iidian straderd specifications for electrical items or works in web? please help me.
what are the problems that generally occur in power flows??
what is sevice settings for mccb?How can be it setted?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
Why do we require transformer with less specific weight if supply frequency is increased?
What are the three constants associated with a steady state error?
I want single line diagram for AMF & DG syncronizing panel
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?