Answer Posted / bhaskararao.nakka
AMF means automatic mains failure.
it is used in genset to automatic starting/stopping when
govt supply failure/restore.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
why the check zone and main zone are used for Busbar Protn. scheem?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Why do we perform an open-circuit test and short-circuit test on the transformer?
Advantage of LT panel vs HT panel
main difference between ac and dc?
oil cooled transformer
What is step signal?
what is the use of expulsition protective gap in 11Kv line.
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
how to extend relay operating timing in 24V dc relay card (without using Timer )
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
What is instrumental error?
In Plumbing services What are accessories we consider for a bathroom?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?