Interested to Buy Any Domain ? << Click Here >> for more details...
What is Primary and Secondary Injection Test of CT and
Relay.
- 2 Answers
- 21586 Views
- I also Faced
- E-Mail Answers
Answer Posted / yusuff ibrahim sipchem
Primary imnjection test- to test the circults including the primary circuit, i.e the CT by injecting the current to the busbar at low voltage, thew current will be according the busbar system rated current
Secondary injection test-to test the secondary circuit ony, whcih includes the relay and secondary wiring only. CTs can't be tested with this. in this the current will be normally 0-10Amps
| Is This Answer Correct ? | 6 Yes | 8 No |
Post New Answer View All Answers
What is Negative Potential Bias
What is ramp signal?
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
How eddy current generation support the idea of train braking?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
How earthing of switchgear system to be done.
What is the actual meaning of thermal power efficiency ?
